Created by Alexi
Status: Active
C44d39772388d7917f959bae7c92c1a5?s=30

Test the VU Step 8 of 8

To test the leds, I connected the signal leads form both IC circuits to the posts of the stereo connector. 

Photo

After a successful testing the leds, I changed my strategy for the trim pots. I decided instead of a single pin header to connect the trimpots from the bottom board to top board, I would use two 6 pin female pin headers on the bottom board, and male pin headers for the top board. I also am going to add a barrel jack to connect the power instead of just wires connected with alligator clips. I will post these photos soon.