Treble Booster Screaming Bird

This treble booster is the Screaming Bird. It is a Linear Power Booster tuned for highs. Whether it's overdriving an amp or just adding some highs, it will make your guitar cut through any mix.

Steps

Add To Favorites

Designators and components Step 2 of 5

COMPONENTS

PCB GUITAR BOOST PCB

Resistors
R1   1M   1M OHM 1/4W 1% METAL FILM RESISTOR
R2   470k 470K OHM 1/4W 1% METAL FILM RESISTOR
R3 Jumper
R4   47k 47K OHM 1/4W 1% METAL FILM RESISTOR
R5   390    390 OHM 1/4W 1% METAL FILM RESISTOR
R6   10k 10K OHM 1/4W 1% METAL FILM RESISTOR
R7 Jumper

Capacitors
C1   2.2n   2.2NF 100V 5% POLYESTER FILM BOX TYPE CAPACITOR
C3   2.2n   2.2NF 100V 5% POLYESTER FILM BOX TYPE CAPACITOR

Transistor
Q1 2N5088 2N5088 GERENAL PURPOSE TRANSISTOR

Potentiometer
VOL 100k-A 100K OHM LOGARITHMIC POTENTIOMETER

PCB (LINK)

PCB SCHEMATIC

The following table shows several projects that you can build with the DH.A8 PCB. Note that some components are jumpers or are not mounted.

GENERAL DESCRIPTION OF COMPONENTS

Resistors

Use a multimeter or the color bands to obtain the resistance value. Resistors do not have polarity, you can place them in any direction.

Electrolytic capacitors

Electrolytic capacitors have their value printed on them. The negative polarity pin is indicated by a white strip along the can. They also have a longer leg indicating the positive pin. The maximum voltage rating never can be exceeded, make sure you are using at least double voltage rating than your power supply. For example, if you are using a 9V power supply, use a electrolytic capacitor with at least 18V maximum voltage rating.

Polyester capacitors

Polyester capacitors have their value marked with three numbers. Read as picofarads (pF), the first two are the 1st and 2nd digits and the third is the multiplier code. These capacitors do not have polarity, you can place them in any direction.

Ceramic capacitors

Ceramic capacitors have their value marked with three numbers. Read as picofarads (pF), the first two are the 1st and 2nd digits and the third is the multiplier code. These capacitors do not have polarity, you can assemble them in any direction.

Diodes

Diodes have their model printed on them. The polarity (cathode) is indicated by the ring near the side. This ring is also marked on the PCB.

Led diodes

Led diodes have polarity, the cathode is indicated as a flat surface on the side of the diode and also it is the shorter led. On the PCB, the cathode is marked as a flat side and anode as a round side.

Transistors

Transistors are three terminals components and their model is printed on them. To indicate the correct orientation, one side of the transistor is flat and the other one is round.

Potentiometers

Potentiometers have their resistance value marked on them. They are marked with A, B or C for logarithmic, linear and reverse logarithmic, respectively.