Purple Plexi 800
The Purple Plexi is a powerful distortion pedal with plexi-style amps tone. It is very dynamic and touch-sensitive distortion, perfect for rock music.Steps
Categories
Status: Active
PCB assembly Step 3 of 5
The PCB is designed to mount angled potentiometers directly on the PCB as follows.
Use a soldering pencil of 15-30W and solder wire of 1 mm diameter. The soldering will release fumes that are harmful to your eyes and lungs, work always in a well-ventilated area.
Warm up the soldering iron and clean the tip with a humid sponge. Heat the PCB pad and the component leg simultaneously and melt 1-3 mm of solder wire on the joint. Finally, cut the remaining of the component legs. Make sure the solder flows properly on both pad and component leg. If the solder has not been applied correctly, you could make a bad connection (cold solder joint). A good connection has to cover the joint without touching any adjacent pad.
Place the components on the footprints following the designators. You can place the components on both PCB sides, just keep the correct polarity. Solder the components from small to big size: resistors, diodes, capacitors, transistors, potentiometers...
