PCB for 1590BB enclosure (horizontal)

This board will help to build your DIY guitar pedal in the 1590BB enclosure. Led, jacks and footswitch are mounted on the PCB, being only necessary to wire the battery and the effect PCB.
Steps
  1. Overview
  2. Designators and components
  3. PCB assembly
  4. Wiring
  5. Drilling template
  6. Example: Les Lius
  7. Example: Box of Rock
  8. Example: Biff Muff + Boost
  9. Example: Full Drive
  10. Example: Centaur Overdrive
  11. Example: Overdrive + Boost
  12. Example: Amp Eleven
Categories
Tayda Electronics Kits, DIY Projects, DIY Guitar Effects
Created by DHEA
Status: Active
6ad5cfedb16d6a272994ad5c2b2b82c7?s=30

PCB assembly Step 3 of 12

Use a soldering pencil of 15-30W and solder wire of 1 mm diameter. The soldering will release fumes that are harmful to your eyes and lungs, work always in a well-ventilated area.

Warm up the soldering iron and clean the tip with a humid sponge. Heat the PCB pad and the component leg simultaneously and melt 1-3 mm of solder wire on the joint. Finally, cut the remaining of the component legs. Make sure the solder flows properly on both pad and component leg. If the solder has not been applied correctly, you could make a bad connection (cold solder joint). A good connection has to cover the joint without touching any adjacent pad.

 

PCB ASSEMBLY

Mount the footswitch, jacks and diode in the enclosure. Adjust the high of the nut and washer of the footswitch. Use the enclosure to adjust the position of the components before soldering. To hold the DC jack, use a DC connector (without power). Make sure this connector is centered in the hole and doesn’t touch the enclosure when inserted. For the 9V battery clip, pass the cables through the two holes near the battery pads. Solder the red wire to the positive pad (+) and black wire to the negative pad (-).

Connect the ground to the enclosure to reduce noise. Solder a cable between the pad marked as “GND” and the footswitch washer.

     

The assembling method is similar to the one described for the DH.E14 PCB (for 1590B enclosure).

 

 

 

Next Page >>
<< Prev Page