Fuzz Factory

The Fuzz Factory is a five-knob fuzz pedal with huge range of sound possibilities. This is classic DIY pedal project that can be built with either germanium or silicon transistors.
Steps
  1. Overview
  2. Designators and components
  3. PCB assembly
  4. Enclosure and wiring
  5. Enclosure drilling
Categories
Tayda Electronics Kits, DIY Projects, DIY Guitar Effects
Created by DHEA
Status: Active
6ad5cfedb16d6a272994ad5c2b2b82c7?s=30

Enclosure drilling Step 5 of 5

Choose an enclosure (www.taydaelectronics.com/hardware/enclosures.html) and use the drill service (www.taydaelectronics.com/hardware/enclosures/enclosure-custom-drill-service.html). You can also use the UV printing service (www.taydaelectronics.com/hardware/enclosures/enclosure-uv-printing-service.html).

Add the coordenates from the following table in drill.taydakits.com. The holes #1 to #5 are for the 1590BB enclosure PCB.

 

Adjust the diameter of hole #3 for the DC connector (9 mm works for most of the connectors).

Adjust the diameter of hole #5 for the LED as follows (for painted enclosures):

  • 3 mm LED: 3.2 mm
  • 3 mm LED metal holder: 6 mm
  • 5 mm LED: 5.2 mm
  • 5 mm transparent holder: 6.5 mm

<< Prev Page

Products